Billy Bob Teeth Fitting Instructions

Easy to follow, step by step fitting instructions to get the best fit for your Billy Bob Teeth

1. Step 1: Pre-fit the veneer teeth to match the curve of your arch by placing them in hot water to soften the material (Do not try and carry out step 1 without heating the veneers as this may cause them to snap)

   

2. Step 2: When the veneer has become soft and flexible, take them out of the water and fit them over the front of your teeth.

   

3. Step 3: After softening the fitting pellets in hot water, form a piece into a 2-½ inch long snake about ¼ inch thick.

   

4. Step 4: Push the fitting material onto the back of the veneer teeth behind where the teeth are. Make sure to push some of the material into each of the two small holes on each side of the appliance

   

5. Step 5: Place the veneer onto your teeth in an upward motion (use a downward motion for lowers) Push any excess fitting material onto the back of your teeth with your fingers and tongue.

   

6. Step 6: Hold in place for approx one minute, then gently pry the appliance loose and re-seat to break any undercuts. After approx two minutes you can remove the veneer teeth. Let cool completely before trimming

   

7. Step 7: To trim, you can use small scissors, nail clippers or a craft knife. The idea is to trim away any plastic behind your front teeth. The appliance is designed to snap on over the front of your teeth and you usually wont need any fitting material behind your teeth where it may affect your speech