How to apply a Water-Melon Prosthetic

We are using the "Scary Kerry Kit and one of the Slashed Wrists Remember everything you need to apply these prosthetics is included in the pack so there is no need for you to buy anything else to use these prosthetics.

1. Apply Alco-Activator™ (99% Isopropyl Alcohol) liberally to the area the appliance is to be attached to.

   

2. Place the appliance into the still wet Alco-Activator™. Try to remove as many air pockets under the piece as possible. Press and hold the appliance in place until it bonds.

   

3. Continue laying the appliance into the alcohol, pressing as you go.

   

4. Apply Alco-Activator™ to the top of the appliance, This makes the appliance almost clear. No need for foundation. Maybe a little blood colour though.

   

5. Blend the appliance with alcohol. This improves the clarity and softens the plastic. Sometimes your finger can help blend the edge too if the Water-Melon™ is soft enough.

   

6. Apply Duracolor™ Alco-Activated Colour™ to the cut. Begin with the darker colour to show depth. This kit has Maroon as the darker colour.

   

7. Apply Red Duracolor™ to the cut. No need to be pretty or perfect.

   

8. Apply red Duracolor™ to any area outside the cut that should have blood

   

9. Keep the pattern random but at the same time logical. The blood should have a reason but also needs to look organic or natural. Not contrived.

   

10. Then, when you have had enough and are ready to scream just remember when you had to worry about REMOVAL. Do you have remover? Do you need remover? Not with Water-Melon. It peels off AND is reusable if you're careful when peeling.